![]() Ensure the malfunction indicator lamp (MIL) is in OFF status before starting the cycle.To run the monitor, drive your car around for 10 minutes at 45 to 65 mph on the highway.Ensure the ignition voltage is between 11 and 18 volts.Barometric pressure must be above 75 kPa.The ambient temperature must fall between 30 and 95 degrees. Allow your vehicle to rest for up to eight hours without turning on the engine.So, ensure your fuel tank is ¼ to ¾ full. An EVAP self-check may become inaccurate if your fuel level is extremely low. ![]() Here are the conditions that enable you to run a complete EVAP monitor drive cycle: But you must take some precautionary tips to have a successful outing. So, the right thing to do is to run a complete cycle. Tips to Run a complete EVAP monitor drive cycleĪs I mentioned earlier, an incomplete drive pattern may cause EVAP monitor not to be ready.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |